Angela Ryczkowski is a professional writer who has served as a greenhouse.

Locate your patches where you most need cover and forage while taking into consideration your own ease of access for follow-up treatments, deer-stand locations and more.

For frill or girdle treatments: Using a hatchet, machete, or similar device, make cuts through the bark at approximately equal intervals around the tree.

Make at least one cut for every 3 inches of DBH on the target tree. For example, a 3 inch DBH tree will receive 1 cut and a 6 inch DBH tree will receive 2 cuts. Spray or brush the. CUT STUMP TREATMENT WITH FRILL OR GIRDLE - VIRGINIA General Information Resistance Management Guidelines - Development of plant populations resistant to this herbicide mode of action is usually not a problem on rangeland, permanent grass pastures, Conservation Reserve Program (CRP), or non-cropland sites since these sites receive infrequent.

Jun 29, The cut stump treatment method is effective on almost any size woody invasive plant including large woody vines. However, small stems less than a half-inch in diameter are not consistently controlled. What is the best time of year to use this method? Cut stump treatments can be done almost any time of the year with most woody invasive stumpcut.barted Reading Time: 5 mins.

When applying herbicide to a cut stump or a girdle, I would apply the herbicide until the area was completely saturated and often starting to drip down the stem.

The herbicide would form a foam after repeatedly dabbing the paint brush onto the stump or into the cuts. The cuts and a distance of the stem. up with a chemical treatment (see cut-stump treatment in the “Chemical Control” section). Girdling – In late spring to midsummer on larger trees, use an ax, saw, or chain saw to make two april dollar tree hauls, circumferential cuts around the entire trunk.

Place one cut 3 to 4 inches above the other through the bark and cambial tissue.