First try, the thing fired up with no hesitation.

Oct 19, How I pull an automatic pilot bushing from a Nissan KA24DE, I've done this many times, i had some trouble the first time but I've got it figured out after ye. move the bearing caps one turn of each bolt at a time until all are free of tension.

Remove the bearing caps and place them in a clean area in the same order they are removed. Remove the old cams, caution should be taken to insure that they don’t bind on the thrust surfaces of the first journal (this is also criti.

Apr 10, Removal of the Automatic Pilot Bushing - Lessons Learned. So my poor Z has been out of commission since January with tranny problems, and with the weather warming up I started work on a long overdue 5 spd swap. Thus far there have been many snags along the way mostly attributed to mutant Japanese rust on nuts and bolts. ALL MY VIDEOS ARE IN p HI DEF SO CHECK THAT OUTcar is a 70 chevelle and i had to remove the old pilot bushing out of my all i used was wheel bearing g.

We have the best Loaner Pilot Bearing Puller Attachment for the right price. Buy online for free next day delivery or same day pickup at a store near you. 20% off orders over+ Free Ground Shipping.

stumpcut.bar Presents; sx KA24DE & SR20DET Throw Out Bearing Removal & Install. Visit website for more DVDs plus Free FSM downloads! Get superior performance with Nissan aftermarket parts from Enjuku Racing. Shop tuner parts, Japanese performance parts & more. Join our Rewards Program & save! Sep 28, woa woa wait a minute!

Fit like a glove btw.

I think you might have found my problem, you said the pilot bushing centers the main shaft to maintain balance/power right? would i feel a loss of power if the end of the mainshaft wasnt sitting in the pilot bearing correctly? when i put my competition stg4 clutch in i noticed my pilot bushing was destroyed and the end of the mainshaft was skiny and wasted but the. Feb 05, You can break down and buy the"Pilot bearing removal tool" or just use some kind of hook contrapition.

I used a piece of threaded rod with the end bent into a hook. Then I bent the hook into a configuration that would pull on the top and bottom. That with kano-kroil and a ball-peen hammer eventually did the trick. weeping yews shrub trim