Contact your state pesticide regulatory agency to determine if a product is registered for.

applied to the freshly cut surface at the proper strength. Unwanted plants should be cut off close to the ground just prior to treatment.

The sooner the herbicide is applied, the more effective the treatment will be. On small stems or on plants that have been cut previously and subsequently re-sprouted, the bark may be frayed to expose more phloem.

Jun 29, Cut stump herbicide treatment is a simple way to control woody invasive plants. An herbicide solution is applied directly to the stump top immediately after cutting down the plant.

Treat when weeds are actively growing and not stressed by drought or other conditions.

The herbicide kills the stump and prevents new growth that would normally occur after cutting stumpcut.barted Reading Time: 5 mins. Stump Swabbing: Stems should be cut less than 15 cm above the ground. Immediately apply GRAZON/diesel mixture liberally to the freshly cut stump or paint the cut surface and sides of the stem. Cut Stump application is the preferred method for saplings that are too small to be stem injected.

Cut stems as close to the ground as practical, no higher than 10–15 cm from ground level. Thoroughly spray the herbicide mixture immediately after the cut is made; this is necessary because the plant can seal the cut quickly, thus barring the chemical from penetrating into the sap stream. Spray sides of stump, including any roots above the soil surface, and the outer portion of the cut surface, including the cambium ring along the inner bark.

Thoroughly wet the stem and root collar area, but not to the point of runoff. Treat any time of year, as long as snow or water doesn’t prevent proper application.

Simple, convenient weed control. GrazonNextHL herbicide simplifies pasture weed control, allowing ranchers to focus on other aspects of their ranch.

Rate selection is simple. Go with2 or pints per acre for most weed complexes. And one application provides season-long control. or to intact plants as a basal bark application. For either application, apply the ready-to-use Pathfinder II to wet the stems, but not to the point of run-off.

Stump treatment is a very effective way to enhance a mowing treatment. Pathfinder II is oil-based, and can be applied after a.